Archives May 2018

My First Gas Plane Flight

I have probably over a thousand hours of electric RC flight time. But this was my first gasser flight. It’s a great plane but unfortunately the engine cutout on takeoff. I luckily saved her. This was my buddy and his dad’s plane but they’ve always had bad luck with it so they trusted me to take her up. We suspect that the line got clogged from some particulate in the tank. The gas dried up once before and it must have loosen up some flakes.

Well watch what happens. Fullscreen the video because my friend Ken is a jerk and doesn’t know how to turn the phone sideways to make a decent video, lol. Also listen to when the engine cuts out on me.
Don’t forget to LIKE & SUBSCRIBE too.

It's only fair to share...Share on facebook
Facebook
Share on google
Google
Share on twitter
Twitter
Share on linkedin
Linkedin

Magic Time-Lapse Video of Mask

Yesterday I started this print last night and it took about 15 hours to complete. It was very large and I experimented with a different pattern for the top and bottom infill, the. It also has a 5% infill on the base with a 3D honeycomb design for strength while saving plastic and print time.

FileFinalMask5.gcode
Filament (Tool 0): 48.91m / 117.65cm³
Approx. Total Print Time15 hours


Print Time14:58:55

My Make on Thingiverse: https://www.thingiverse.com/make:487301
Please watch the video below. It turned out great. LIKE & SUBSCRIBE

 

 

It's only fair to share...Share on facebook
Facebook
Share on google
Google
Share on twitter
Twitter
Share on linkedin
Linkedin